Trochoidal milling Due to the trochoidal milling process, large depths of cut are also possible on unstable and weak machines. Depending on the tensile strength of the material, the radial infeed is 5–20% of the cutting edge diameter. As trochoidal milling is a plain milling process, the forces that occur are lower. When trochoidal milling a slot, the milling cutter diameter should be a maximum of 70% of the slot width. Example: Slot 20 mm x 70% = 14 mm A Ø 14 mm milling cutter would be the perfect tool. Material Depth of cut Radial infeed Feed vc Correction factor Correction factor Steel 2xDC 0,05xD 3,5 1,6 2xDC 0,10xD 2,5 1,3 Stainless steel 2xDC 0,05xD 3,5 1,4 2xDC 0,10xD 2,5 1,2 Cast iron 2xDC 0,05xD 3,5 1,6 2xDC 0,10xD 2,5 1,3 Non-ferrous metals 2xDC 0,05xD 3,5 1,8 2xDC 0,10xD 2,5 1,4 2xDC 0,20xD 1,5 1,2 Heat-resistant 2xDC 0,05xD 2,5 1,4 2xDC 0,10xD 2,0 1,2 Hardened steel 2xDC 0,02xD 2,5 1,5 2xDC 0,05xD 2,0 1,3 Benefits ▲ Lower tool wear ▲ Reduced machining time ▲ Utilization of the full tool cutting edge ▲ Reduction of the cutting forces Most CAM suppliers offer an application for trochoidal milling. Our recommendations for this application are as follows: Please note that the values specified sometimes have to be reduced due to the component design, machine stiffness, and machine dynamics. Under optimal conditions, the values can be increased instead. Solid Milling Technical Information