~36° ~45° ~60° TQ 18,000 – 19,999 1,5 Nm 20,000 – 21,999 2,5 Nm 22,000 – 26,999 4 Nm 27,000 – 34,999 5 Nm 35,000 – 41,999 6 Nm 42,000 – 51,999 10 Nm 52,000 – 65,000 13 Nm 1 2 3 Ø 18,000 – 31,799 mm ZEFP 6 Ø 31,800 – 51,999 mm ZEFP 8 Ø 52,000 – 65,000 mm ZEFP 10 ZEFP 6 ZEFP 8 ZEFP 10 ~ 60° ~ 45° ~ 36° ~ 15° ~ 0,006 mm ~ 15° ~ 0,003 mm ~ 18° ~ 0,005 mm ~ 30° ~ 0,012 mm ~ 30° ~ 0,006 mm ~ 36° ~ 0,010 mm ~ 45° ~ 0,018 mm ~ 45° ~ 0,009 mm ~ 60° ~ 0,024 mm 5 6 2 3 1 2 3 1 2 3 1 4 4 5 1 2 3 4 5 Reamax TS – Assembly instructions Ø Range Tightening torque (TQ) Clean the Morse taper adapter/face contact → grease-free. Screw the pull stud (5) into the reaming head and tighten using the open-ended spanner (6). Use the key (3) to close the jaws (2), observe the recommended tightening torque. When inserting the reaming head (1), this is pulled into its final position when the jaws (2) are closed. Use key (3) to open jaws (2), but do not fully release, and insert reaming head (1). When removing the reamer head (1), this is pressed out of its position by the jaws (2) and can thus be easily removed from the holder: Use key (3) to open the jaws (2) but do not fully release, and remove reamer head (1). Caution: For technical reasons, all Reamax TS reaming heads and Reamax Mono reamers have an irregular cutting edge pitch. For this reason, the angles specified above are approximate values, to make handling easier. If the required diameter is over turned, turning back the adjustment screw is not enough! If this occurs, the reaming head/reamer must be fully released and re-set again. This adjustment facility is only intended to compensate for wear. Therefore, an adjustment of 0.015 mm in diameter should not normally be exceeded! The adjustment values given above are recommended values based on empirical values and test results. However, these may vary slightly from case to case. Adjustment for wear compensation: The smallest drilling tolerances up to IT4 can be achieved through adjustment with the hex key (4). ZEFP = Number of effective cutting edges, around the periphery Pitch Turning the hex key by ~ ...°, results in an adjustment of ~ ... mm in diameter in the Ø in the Ø in the Ø in the Ø in the Ø in the Ø in the Ø in the Ø in the Ø Reaming and Countersinking Technical Information
